News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Lennart Bossér

Pages1
#1
General Tormek Questions / Honing wheel
January 13, 2025, 08:40:09 PM
Hi!
Someone has used our honing wheel (Tormek T8 Black) in counter grinding mode causing an ugly scratch, but not very deep. Is there any way to restore it? Eg. bý sanding it down?

Best regards,
Lennart
Pages1