News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Fragensteller

#1
As I know the pr 250 was meant as a heavy duty machine - for big butcheries, slaughterhouses and so on. On my machine is a sticker from a central-clinic-kitchen. There are some informations here https://forum.tormek.com/index.php/topic,4040.msg27977.html#msg27977

Lets see what the support will answer :-)

Greetings

Thomas





#2
General Tormek Questions / PR - 250 Renovation Project
November 02, 2024, 04:31:45 PM
Brandnew member and also a new one in the tormek world :-)

Located here in germany and a self-sharpener for many years - but more on the rough and uneducated side.

Now i got a present from an old man here in my neigbourhood. A tormek PR-250 in a deeply negected condition.

After a lot of cleaning and derusting its running again! I sharpened some stuff free-handed to test the machine an i am realy pleased with this old machine.

Sadly there came not a single piece with it.

My first question is - what support bar fits and where can i find one.

Any suggestion is highly appreciated.

Best Regards

Thomas