Messages

Thank you very much for your answer, when i read it, i noticed, that the body of the drill bits is a lot smaller than the tip.
when i read the infos correct, the DBS-22 ist only able to handle Drill Bits up to 22 mm and all the bits greater 1" have a body that is 24mm to 1" thick.

now i'm thinking about buying the DBS-22 for all the smaller bits 

Hi everyone,
I own a Tormek T-4 and look for a way to sharpen the Drill Bits I use for drilling Bowlingballs.
that bits have diameters from 1/2" to 1-1/2", a welded hard metal plate on top and therefore only two angles, the drilling angle with ca. 118 degrees and the angle of the cutting edge of approx. 10 degree. i've attached a foto with one bit.
You cannot view this attachment.


do you think, there is an attachment for the Tormek, so i can sharpen this bits easier?

sorry about my bad english, also i don't know the exact techical names of a drilling bit.

greetings from hamburg/germany

Stephan