News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - HandLogger

#1
Hi Ken ~

You made reference to the phrase "early T7s" in your response.  How does one go about determining whether or not they own the earlier model that you're referencing? 

Needless to say, if the "early" distinction indicates a design flaw of some kind, I'd like to know what to look for.

Have a good one ~
HL
#2
Hi to the Tormek Community!

As we once had plans to put the traditional timber framing skills I learned as a much younger man to use on a home of or own, we purchased a slightly used T-7 sharpening system back around 2007. 

As I see that this system has been replaced by a newer system, known as the T-8, I'm wondering what the differences are between the older and the newer system?  I'd also like to know if it's still possible to get all of the parts for the T-7 system? 

If most of the jigs intended for the T-8 are interchangeable with the T-7, I suppose that we're still in good shape, but that's why I'm asking about the differences between the two systems.

Thank you kindly for your time ~
HL