News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - huntrashmi

#1
Hi everyone,

I bought a used T-4 and I suspect the previous owner used too much oil and/or honing compound. The honing wheel is pitch black and leaves a horrible mess every time I use it - leaving a thick layer or residue on my tools and sticky crumbs all around the T-4. Is there any way to clean up the honing wheel? I tried an old eraser, with little to no effect.

Any tips are much appreciated!