Thanks Rich ... will try this.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Wood Turning / 30 to 35
Yesterday at 03:49:13 PM
I bet this must be out there somewhere but can't find the thread, sorry. The t8 handbook gives examples for spindle gouges for 30 and 45 degree bevels and shows the 3-step recipe (hole, protrusion, 186 setting). I'd like to re-grind a SG via my BGM-100's/grinder from 30 to 35 degree bevel before transferring over for final sharpening on my t8 but can't understand whether to use hole A or B on the TTS-100 as it's not mentioned in the handbook. Hope I've explained myself OK here or am I missing something! Anyone able to help with this, please?
#3
General Tormek Questions / Bowl gouge with 30 degree angle
June 22, 2024, 07:59:01 PM
Sorry if this has been asked, many times, before! I have a bowl gouge with a 30 degree bevel (it's def a BG!) I will re-grind most probably very soon but for now, how do I set the jig on my T8 to sharpen this, please? Does not appear to be a setting for this. I presume I cannot treat it as a spindle gouge?
Pages1