Quote from: Columbo on July 11, 2024, 01:50:57 AMYeah, same here with mineInteresting... might be a bad batch.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Re: New T8 Black issue
July 11, 2024, 04:13:20 PM #2
General Tormek Questions / Re: New T8 Black issue
July 10, 2024, 04:29:01 PM
Wolfgang replied, just sent him a video of the problem.
#3
General Tormek Questions / New T8 Black issue
July 09, 2024, 06:39:52 PM
Hello fellow grinders.
Just upgraded to a new T8 Black from a T4 and found that I cannot mount the DF-250 on the correct side. It easily mounts when I flip the wheel with the plastic wall on the outside but when I flip it over to the correct side (grit wall facing out) the bore won't go past the end of the shaft threading.
Checked for burrs on the inside but it feels smooth.
Just upgraded to a new T8 Black from a T4 and found that I cannot mount the DF-250 on the correct side. It easily mounts when I flip the wheel with the plastic wall on the outside but when I flip it over to the correct side (grit wall facing out) the bore won't go past the end of the shaft threading.
Checked for burrs on the inside but it feels smooth.
Pages1