thank you for all your input. I went ahead a purchased a new SG 250. And rod. So I'm set to learn more.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / locked out
December 30, 2023, 02:40:15 AM
This probable will sound pretty dumb. I purchased a used T8, awhile back (with all the accessories). I did my best to learn to use it. Then I got lazy, and it set for A While. I always sharpen my wife's knives. So, I got all ambitious to sharpen. I planned to get a new stone for the T8. When I went to remove (SG-250) I couldn't budget loose the nut. The wheels turn. Holy smokes it's like "locked" tight. Any suggestion for this dumb move.
Luckily I have a work sharp. My wife has some sharpened knives, whew - for that.
Thanks for anything. 🙂
Luckily I have a work sharp. My wife has some sharpened knives, whew - for that.
Thanks for anything. 🙂
#3
General Tormek Questions / New to the Forum
December 30, 2023, 02:15:42 AM
Here to learn. I do amateur sharpening.
Pages1