News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - mjninc

#1
I used the tormek for my first serious try at sharpening knife recently.

Do you normally have to take off the grinding wheel to use the leather wheel?

I used the guide rail on the front of the Tormek and I was just sharpening a normal size steak knife, and a handle hit the grinding wheel.

Maybe the setup was wrong?
#2
Thank you!
#3
Thank you for the responses!

Is this a front vertical base?  This is what I have, do the same principles apply?

#4
Hi, I'm new to Tormek and have a Supergrind 2000 with a vertical front base.  I'm trying to learn how to use angle calculators to learn how to sharpen like I've seen on Knife Grinders Australia Youtube channel. 

I want to do the best I can with what I've got, just the Supergrind 2000 and the leather wheel (with green rouge).   

I think I can get the angle right for the wheel, based on one of the videos, but I don't know if there is a video that shows how to set the angle for the leather wheel with a caliper.

Do you know of any videos (or pictures) that show how to set the angle on the front vertical base (with a caliper?) for the leather wheel?

Thank you for your help!