News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - TomP2

Pages1
#1
Knife Sharpening / Re: Chord-Tangent Angle Compensation
February 11, 2024, 11:28:15 PM
Hi, I am a complete Newby and read this thread carefully. There is one thing I still do not understand: the USB Base point (height). What is it needed and adjusted or measured? Maybe it is a dumb question, but I don't currently own a Tormek.
Thanks for understanding and support!
Pages1