News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - PerAtAptomica

Pages1
#1
Drill Bit Sharpening / Re: Can this drill point geometry be sharpened on the tormak?
September 26, 2023, 04:07:14 PM
Hi Helmut

Thank you for your help, I will check out your post and would be very interested to know how you modified the jig DBS-22 to make it happen.

I will report back when I have worked more on this.

All my best
Per
#2
Drill Bit Sharpening / Can this drill point geometry be sharpened on the tormak?
September 26, 2023, 12:54:03 PM
Hi all

I use a drill with this particular tip geometry (photos attached) and it works great for me.

What I wonder is if I could sharpen this on the Tomak, I do not think the DBS-22 can do it.

The part that worries me the most is the sharp corner in the center.

I am considering 3D printing a simple custom jig and see if I can make that work.

The surface Marked A is concave and the surface marked B is convex.

Any suggestions are much appreciated.

All my best
Per
Pages1