I have encountered a similar issue about keeping the blade flat on the stone. The blade holder keeps hitting the post of the threaded part of the universal support bar. I am unable to slide the blade holder smoothly along the bar. What should I do to avoid this?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Use of Angle Setter KS-123
December 11, 2024, 02:00:08 AM
Does the KS123 work with narrow width knives? I could not get the blade edge to rest on the guide without running out of the knife holder stem. I am using a T4. Any tips to resolve this issue would be highly appreciated.
#3
Knife Sharpening / Re: Advice for good sharpening technique on cleavers
September 27, 2023, 02:52:01 PM
Tried to sharpen a clever using a T4. I could not achieve the correct blade edge without using the second stopper of the jig, otherwise the bevel tends to widen. Is this acceptable? Any advice on how to avoid widening the bevel on a clever? Appreciate the expert advice.
Pages1