News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Nickp

Pages1
#1
General Tormek Questions / Re: Moulding Knife Jig
August 01, 2023, 10:14:40 PM
I did, thank you.

Nick
#2
General Tormek Questions / Re: Moulding Knife Jig
July 28, 2023, 06:19:22 PM
Thanks Ken! I figured that was the case since I didn't see any recent posts by him. Thanks for jumping in. I watched a Tormek live video on youtube on this jig and it gave me some hope i could possibly use it as is as long as I can get the pins to cover multiple points on the knife. Hopefully there's something in the works though.
#3
General Tormek Questions / Re: Moulding Knife Jig
July 28, 2023, 04:34:45 AM
Quote from: Jeff Farris on October 28, 2008, 08:07:31 PMCan't say for sure, but the current direction is toward a new blade holder that uses the current support system.

Hi Jeff - Found this old post, I have a Williams and Hussey Moulder... did you have any luck with an improved design? I was thinking of picking up this jig, putting my engineering/ fabricator hat on and seeing if I could modify it myself... but much prefer not to reinvent the wheel if it's already out there.

Thanks,
Nick
Pages1