News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Willowatt

Pages1
#1
General Tormek Questions / Re: T-8 Diamond wheel not fitting
May 23, 2023, 01:45:08 AM
Thanks!
I did send them an email, but they said they have a holiday. Just me being impatient, and wanting to try out the new machine. But also wanted to see if others had experienced something similar with a newly released edition of the machine.
Thanks
#2
General Tormek Questions / T-8 Diamond wheel not fitting
May 22, 2023, 10:05:01 PM
Hello,
I just received my new T-8 Black today, but i can not get the diamond wheel (DF-250) to fit on the shaft. I can get it to fit backwards for some reason, but not in the correct orientation. I can't even get it on the shaft a little bit. I tried tapping it with a hammer but nothing. I thought about running some sand paper over the shaft while it was on or running a file through the diamond wheel, but I'm afraid i am going to mess up the balance my new machine or on the wheel.
Is the wheel or the shaft defective?
Any suggestions?
Thanks
Pages1