Messages

Good evening,

First of all, I would like to sincerely thank you for the time you have devoted to answering me.

After 4 hours in my workshop, I think I have found the problem. All the tools I'm trying to get back into service are very old.

The series of the first 6 wood chisels that I tried to sharpen do not have their parallel side. If I take an example for one of them at the edge, the width is 30 mm and 5 cm from the edge the width is only 26 mm. by putting myself perpendicular, I create this famous angle, as we can see on the photos in the top of this topic.

I have not yet found a way to sharpen this type of tool, but with the device SE 77, I suppose that you have to use the Screws (5) to correct this bad angle.

I didn't understand everything, but I'll try again tomorrow
If you have any advice on how to make an adjustment I am a taker.

I don't really know how to look for topics on the forum I don't have enough vocabulary, I guess this type of case has already been dealt with, if you can help me find links, I can translate with google

Thanks again for all your advice.

Hello, first of all I'm not a champion in English, but I don't really know how to do it, all my wood chisel sharpening is crooked. The result is always same 



I make sure that the adjustment of the support is well aligned.



When I put my wood chisel in the holder, I take my square and I make sure that there is a right angle



And the result for all sharpening is always the same... Always wrong, I don't know what to do.




I watched all the tutorials on youtube, and I've never seen this type of problem, my tormek T8 is new...
If you can help me, give me a clue, that would be great!