Tormek got back to me and it doesn't look like they have anything that can fix it. I've ordered some flanged bearing bushes that seem to be the right size. Fingers crossed they might fit.
Thanks
Thanks
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Stone wobble
December 19, 2022, 07:31:54 PM
Thanks Ken
I'll contact support and let you know what they suggest.
Andrew
I'll contact support and let you know what they suggest.
Andrew
#3
General Tormek Questions / Stone wobble
December 19, 2022, 02:38:38 PM
Hi
I was recently given an old Tormek SA-250. The motor seems in good order but the stone wobbles. It looks like a nylon bush runs through a hole in the centre of the stone and is held in place by a washers at either end. Both these washers are no longer attached to the stone and the bush is broken. Do you know if there is an easy fix for this problem? Ive attached a few few photos. Thanks for your help.
I was recently given an old Tormek SA-250. The motor seems in good order but the stone wobbles. It looks like a nylon bush runs through a hole in the centre of the stone and is held in place by a washers at either end. Both these washers are no longer attached to the stone and the bush is broken. Do you know if there is an easy fix for this problem? Ive attached a few few photos. Thanks for your help.
Pages1