News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Tlytle25465

Pages1
#1
Wood Turning / Question about honing an Ellsworth shaped bowl gouge
May 10, 2022, 10:04:18 PM
Trying to sharpen and hone my Ellsworth shapes 1/2" bowl gouge with my new Tormek T-8 and the tool does not line up with the honing wheel.   
The set up is JS = 6, P = 65 & Hole A on the jig

Here is how things line up.  Should I just hone by hand or am I missing something?
Pages1