News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - losdottos

Pages1
#1
General Tormek Questions / Re: Tormek T-8 switch does not stay in the ON position – three switches tested
November 21, 2025, 01:07:24 PM
Sorry to ask, but do you have a 110V or a 230V machine? I found the following answer, which describes your problem, in faq.tormek.com.
Hi Franz.

If you have a 230V machine you cannot use it on 110V power. Both the motor and main switch are voltage specific for 230V or 115V. The coil inside the 230V main switch will not draw on 110V. It needs at least 180-190 Volt to stay on.

regards
Mats
#2
Hand Tool Woodworking / Re: Bevel Angle accuracy
May 03, 2025, 02:03:14 PM
Quote from: Hugh Proudman on April 30, 2025, 10:24:46 AMI have been careful to set the stone diameter on the AngleMaster,
Sorry to ask, but are you setting the real stone diameter, i.e. diameter of a new stone minus wear? Or are you setting 250mm for the T7 and 200mm for the T4?
#3
General Tormek Questions / Re: used tormek supergrind 1200
January 18, 2025, 02:20:40 PM
https://www.youtube.com/watch?v=wKHyTAx4ExA
https://www.youtube.com/watch?v=2JOWFdEGCFY
These tutorials should help you. Afaik all actual jigs for T8/T4 fit to your machine.
#4
Wood Turning / Re: Tormek receipe
December 12, 2024, 07:45:01 PM
Do you mean the Tormek Handbook?
Tormek HB 10
Pages1