Messages

Hello again,

I share with you a pivot collar that can be 3D-printed that will work with SVM-45 - 12mm.

https://www.printables.com/model/188651-tormek-pivot-collar-12mm

Thank you for the warm respons guys, happy you liked it.

It took me a while to get the tolerances right, hopefully it's durable enough for long time use.

I will be releasing a 3D-printable pivot collar for the svm-45, or for any jigg with a 12mm rod.

Thank you again.

-Martin

I have made a version of the original drip tray for the T8 so it can be used with a FVB attached.

Can be downloaded here:
https://www.thingiverse.com/thing:5371503

Seems to be a working prototype, made fit for a M5 screw to tighten the pivot collar.

Hello, I am a newcomer here at the Tormek Forum Community.

Thank you to everyone who is sharing their knowledge and experience.

I might have made something that can be 3D-printed, just started my printer and will know in about 50 mins if I am on to something or not.