Hi Ken, was hoping to find some pre-made stands as I am setting up a commercial sharpening set up mimicking Knifegrinders Aus. But it looks as if I may have to fabricate some and will look for stainless steel or Aluminum to use as material. Thank U for sharing your ideas.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Knife Sharpening / Bench grinder universal support arm stands
February 16, 2023, 05:33:55 PM
Does anyone produce the stands used to elevate and support the Tormek universal support arms like KnifeGrinders Australia used to sell? The stands were used with slow speed bench grinders and CBN wheels.
Pages1