Thank you all so much for the tips. I Believe these are great solutions and hopefully will solve my problems. This weekend is dedicated to practicing
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Hand Tool Woodworking / Re: Newbie needs tips on keeping things square.
October 29, 2021, 03:55:29 PM #2
Hand Tool Woodworking / Re: Newbie needs tips on keeping things square.
October 27, 2021, 02:37:49 AM
Ahh damn autocorrect 
I meant to say done "grinding"
I meant to say done "grinding"
#3
Hand Tool Woodworking / Newbie needs tips on keeping things square.
October 25, 2021, 06:00:38 PM
I have been practicing with my Tormek t8 and I have one issue that seems to come up every now and then that I need some tips from you on how you work through this.
On occasion I seem to set things up properly but then when I am done grinding and I am looking at the grinding marks I see things as being very crooked. Then when I take my square edge to the chisel or plain blade that I am trying to sharpen I noticed that my grinder has taken it out of square. The wheel itself is flat and parallel to the support bar so it does not seem to be that and I feel it is more user error. It does not happen every time so I am wondering from all of you what do you do to help make sure that everything stays square on your tools?
On occasion I seem to set things up properly but then when I am done grinding and I am looking at the grinding marks I see things as being very crooked. Then when I take my square edge to the chisel or plain blade that I am trying to sharpen I noticed that my grinder has taken it out of square. The wheel itself is flat and parallel to the support bar so it does not seem to be that and I feel it is more user error. It does not happen every time so I am wondering from all of you what do you do to help make sure that everything stays square on your tools?
Pages1