I just wanted to chime in on these old posts about modifying the DBS-22 Base Plate. After sharpening over 100 drill bits and having issues with the left side tipping I read about this modification. I cut off 1" using a hacksaw and finishing it with a die grinder and wish I had done this long time ago. I am now really happy with the DBS-22. If you haven't done it yet, I do recommend this mod.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com