yes I have the washer and wheel correct now and I'm ready to begin sharpening.
Thanks!
Bruce
Thanks!
Bruce
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Water well will not raise
April 12, 2021, 08:42:18 AM
Hey all,
I finally got a Tormek T8 yesterday, and when I attempted to sharpen my first knife, the water well will not raise up using the knob. The wellthe instantly contacts the stone and rubs severely. The grinding wheel is so close to the machine housing there's no room for the well to raise. Is there supposed to be a spacer when installing the grinding wheel?
Bruce
I finally got a Tormek T8 yesterday, and when I attempted to sharpen my first knife, the water well will not raise up using the knob. The wellthe instantly contacts the stone and rubs severely. The grinding wheel is so close to the machine housing there's no room for the well to raise. Is there supposed to be a spacer when installing the grinding wheel?
Bruce
Pages1