News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - yukon-rose

#1
General Tormek Questions / Re: S2000 motor removal
March 08, 2021, 02:41:48 PM
>Your best bet is to contact support

Good suggestion. Here is the response I got:

"No you do not have to take the motor apart.

On the inside of the housing you have a cover over the main switch.

This cover can be removed. Underneath you have the wires connected to the main switch with cable shoes.

Just remove them and  the connection point for the earth protection..

Then just tap out the shaft that holds the motor and  then its  loose from the housing."

Perfect. It only took a few minutes to remove the switch. The hardest part was undoing the strain relief.

Gary
#2
General Tormek Questions / S2000 motor removal
March 05, 2021, 05:16:29 PM
I just bought a Supergrind 2000 that is in serious need of an overhaul.

I would like to remove the motor without cutting any wires. In order to do that it appears that I need to take the motor apart.

If you've done that, please offer any suggestions on how you did it.

Thanks.

Gary

#3
General Tormek Questions / EZYlock Thread size?
February 23, 2021, 10:33:27 AM
What is the thread size of the EZYlock nut?
Is the thread a standard VEE shape (60 degree)?

Gary