News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Buckm

Pages1
#1
General Tormek Questions / Re: beyond grading
February 25, 2021, 12:04:18 AM
Ken
  The Graded SG-200 with the #400 and then the #1000. Made the bevel much smoother! You can feel the difference, + smaller wire edge, easier and quicker to polish to finish! Im not sure how long the metal 400/1000 will last but so far so good!

Bryen
#2
General Tormek Questions / Re: beyond grading
February 22, 2021, 03:15:52 AM
I have purchased the Square Jig a #400 / #1000 / #80 grit diamond plate. Also an extra SG-200 as a dedicated 220 and will try and get the other SG-200 to be a 1500. If the results of the 1500 look like the microscope images on the video I would imagine the fine lines would not be so prevalent, before any leather honing.
Pages1