Another roughing gouge question, is the a setting with the SVS-50 using the TTS-100 to produce as 45 degree bevel on the gouge?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Wood Turning / Roughing gouge grind.
January 22, 2021, 04:46:27 PMAnother roughing gouge question, is the a setting with the SVS-50 using the TTS-100 to produce as 45 degree bevel on the gouge?
#2
Wood Turning / Re: Large Roughing Gouge
January 18, 2021, 04:34:33 PM
Thanks for your suggestions.
I have decided to give the collar method a go an ordered one today. Once it arrives I'll get a suitable screw and let you know how I get on.
I have decided to give the collar method a go an ordered one today. Once it arrives I'll get a suitable screw and let you know how I get on.
#3
Wood Turning / Large Roughing Gouge
January 17, 2021, 05:30:36 PM
Hi
I have a large roughing gouge 1 3/4" so too large for the SVS-50 Multi Jig.
Has anyone got any tips for sharpening it on the Tormek or any shop made jigs that would help?
Thanks in advance.
I have a large roughing gouge 1 3/4" so too large for the SVS-50 Multi Jig.
Has anyone got any tips for sharpening it on the Tormek or any shop made jigs that would help?
Thanks in advance.
Pages1