News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Pkfusion

Pages1
#1
General Tormek Questions / Re: Super grind 1200 blue case.
November 25, 2020, 10:26:12 PM
Thank you. I will keep you posted.
#2
General Tormek Questions / Re: Super grind 1200 blue case.
November 25, 2020, 06:07:13 PM
Here is a photo of the label if it helps?
#3
General Tormek Questions / Super grind 1200 blue case.
November 25, 2020, 05:52:36 PM
Hi everyone.  I have had this machine from new with only occasional light use. I would like to register it but am not sure of its age and therefore if it has a serial number?
The main wheel is about 194mm diameter so I guess it has some life in it yet!  I have just for the first time (sorry...) lubricated the bearings and checked that the stone comes off the shaft ok.
Other than my question above I would also like to know if I could fit the Japanese water stone to my machine, obviously the 200mm one.  Have the shafts ever changed size?

Thanks for any help.
Pages1