Messages

Hi thank you for your replies. I find the Anglemaster quite clumsy to use and not easy to get an accurate repeatable result, partly because of the ribbed surface of the platform.
I have looked but I cannot seem to find find a picture of the Kenjig.
I will try the combination square.
Some other sharpening systems have pre-sets of the most commonly used angles for their tool rest which then provide easily repeatable angles, such as the Sorby ProEdge or Ken Riza's Kodiak. I suppose I was hoping for something that simple.
It seems a shame when other aspects of the Tormek system are so well designed and so easy to use to repeat angles.
Richard

Dear All, as a new owner and member please forgive me if this is a foolish question.
Does anyone know if there is an angle setting jig for the SVD-110 tool rest platform which would allow one to repeat the same angle for things such as scrappers, roughing gouges etc without having to resort to the sharpie method? I have seen that some are available for the Wolverine tool rest platform - I do not know whether they would work on the Tormek. Any help / advice would be very gratefully received.
Thanks, Richard