News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - paitos

Pages1
#1
Knife Sharpening / Re: Newbie question about WM 200
March 16, 2020, 03:22:07 PM
Thanks a lot
I did search but I guess  wrong key words  :)
On to read it
#2
Knife Sharpening / Newbie question about WM 200
March 16, 2020, 08:10:30 AM
I am not sure how to use the wm200 on a knife...
I have 2 knifes with the same cutting angle, but one of them have small enough cutting edge 1mm and I can't see use it rightly.... Any suggestions how to do it? In which case I am going to have my 15 degrees?
See attach to understand what I mean.
Sorry for my poor English  :)
#3
General Tormek Questions / Re: New to Tormek. Problem with language
March 13, 2020, 10:24:59 PM
They respond the next day after I send it
They said to send it back to them and they will send an English one!

Thanks for the help
#4
General Tormek Questions / Re: New to Tormek. Problem with language
March 10, 2020, 11:54:06 PM
Quote from: Ken S on March 10, 2020, 02:18:12 PM
Welcome to the forum, Paitos. I agree with Twisted Trees and John. Having the handbook in a usable language for you is essential. And, yes, we are a friendly and helpful group. We have also not forgotten when we were starting to learn to use the Tormek and asked (or are still asking) the same questions.

Ken

Thanks for welcome
Your opinion I should order it or email Tormek to change it?
#5
General Tormek Questions / Re: New to Tormek. Problem with language
March 10, 2020, 01:44:56 PM
I think i ll have many, as soon as i start using it

Thanks ;)
#6
General Tormek Questions / Re: New to Tormek. Problem with language
March 10, 2020, 01:05:40 PM
Problem solved
As soon as i registered with serial No at tormek, it was there online and in english!

#7
General Tormek Questions / Re: New to Tormek. Problem with language
March 10, 2020, 12:30:04 PM
Its new but not from Greece. A friend of mine ordered it for me. I think from Austria but not sure
#8
General Tormek Questions / New to Tormek. Problem with language
March 10, 2020, 12:16:37 PM
 Hi from Greece
My T4 with TNT-708 and SVM-45 just delivered to me  ;D
I am at work and cant test it yet, but the instruction book was in a language i cant even find out what it is... swiss? German? dont know.

Can i find it in English online? Do i need it or am i covered with video tutorials etc?
Pages1