I truly appreciate your calculator that measures directly to the wheel. I how have it on my phone and ipad. Thanks so much.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Old machine nomenclature
February 20, 2020, 05:50:24 AM
Thank you so much for the information. My problem is solved.
I truly like the looks of the calculator referenced.
Thanks again
I truly like the looks of the calculator referenced.
Thanks again
#3
General Tormek Questions / Old machine nomenclature
February 19, 2020, 08:06:55 AM
I have an old Tormek machine that is labeled 2000. There is no T or S in front of the numbers. I would like to use the software provided by knife grinders. They have versions for several models but all have a letter in front of some numbers, not just a plane 2000. They have one for an Super Grinder 2000. Is that the complete name for my machine or is it a different one? Thanks for any help.
Pages1