Messages

Hello -

Thanks for the reply.  I have been watching the videos and for the most part figured out what you said about the micro adjust.  I also suspected as much about the warranty - that is understandable.  Thanks much for the tip on the shaft.  I will check it and keep an eye on it.  The unit I have was barely used at all, so it is probably OK for now.  

I am sure it won't be long before I am going to be looking for additional jigs so you will probably been hearing from me again soon.

Joe

Hello -

Can you tell me what the differences are between the year to year models since 2002?  I just bought a SG that was purchased from SharpTools in late in 2002 and am wondering what I might need to bring it up to the current model.  It has the horizontal base but not the micro adjust tool support.  Is there anything else I am missing?  Also, is the micro adjust upgrade more useful/worthwhile for some applications than others?  If so, which ones need it the most?  Finally, I very much doubt this will ever be an issue, but by any chance is the sharptools warranty transferable?

Thanks