Yes, I have the latest edition 10.4. Also, very weird that the bench heights are given in fractions of an inch.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / sharpening system bench heights
January 29, 2020, 10:08:12 PM
Re. Water cooled sharpening of edge tools pdf:
Page 39, preparation before grinding, working height states At knife sharpening the height of the bench should be 750–830 mm (29½–32 2/3").
But on page 52 and elsewhere, it states The height of the bench must not be too high when grinding knives. 550–650 mm (22–26") is suitable.
Why does the 1st statement vary from the 2nd statement?
Page 39, preparation before grinding, working height states At knife sharpening the height of the bench should be 750–830 mm (29½–32 2/3").
But on page 52 and elsewhere, it states The height of the bench must not be too high when grinding knives. 550–650 mm (22–26") is suitable.
Why does the 1st statement vary from the 2nd statement?
Pages1