I have been using my relatively new Tormek T-8 and love the results. I have sharpened everything in my shop and kitchen, but just recently discovered that my chisels and plane blades are out of square. It is not dramatic, but when i tried to use my block plane and had a problem achieving an even space in the opening, i discovered that the plane blade was sharpened out of square. Looking at a set of bench chisels that I had sharpened with the jig revealed the same and at the same angle or deviation from square.
I remember seeing the adjustment knobs on the SE-77 when I first opened the shipping box and I may have played with them not knowing their function. If I did and adjusted it out of square, how do I recalibrate it back to square?
I've done a search of other posts on the SE-77 but haven't found a post describing how to accurately set square on the jig, just how it works nicely to set camber.
Please help a new user on how to reset square on this jig.
Thanks
I remember seeing the adjustment knobs on the SE-77 when I first opened the shipping box and I may have played with them not knowing their function. If I did and adjusted it out of square, how do I recalibrate it back to square?
I've done a search of other posts on the SE-77 but haven't found a post describing how to accurately set square on the jig, just how it works nicely to set camber.
Please help a new user on how to reset square on this jig.
Thanks