I just received the SVM-00 to use with my SVM-45. When I mount a knife and select any sharpening angle (for example 25 degrees), there isn't enough clearance and the SVM-45 contacts the wheel. I tried changing the handle length on the SVM-45 but there still is not enough clearance. Did I miss something?
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com