Ken, that is good advise I threw mine in the garbage in my shop and when I realized that it holds the shaft in I had to go fish it out of the can. I have since made a sturdier collar by drilling a hole through a piece of dowel.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
General Tormek Questions / Re: Before you mount the wheel on your new Tormek
June 06, 2019, 05:38:22 AMPages1