Email sent, thanks Ken... I'll keep you posted 👍
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / T8 Diamond wheel
October 18, 2019, 02:01:34 PM
Hi all
Has anyone else had issues with the diamond coating on the new diamond wheels when grinding on the side of the wheel. I am sharpening chisels with a flat bevel on the diamond fine wheel using the mb-100 and am starting to see lines around the wheel where the diamond is removed...
Thanks I'm advance
Dan
Has anyone else had issues with the diamond coating on the new diamond wheels when grinding on the side of the wheel. I am sharpening chisels with a flat bevel on the diamond fine wheel using the mb-100 and am starting to see lines around the wheel where the diamond is removed...
Thanks I'm advance
Dan
Pages1