Messages

You're welcome... hope something works out.  (Some of my ideas are "rough" around the edges...).

CB,
I blatantly stole your idea of the "Lansky" holder for my Ulu and other curved blades that are similar. It worked well.
I will be going to the local hardware store and getting some long angle brackets and some screws and bolts,to "Roughly" put together a fixture dedicated to this type of blade. While I am not real good at photo posting, I will post a picture once I get it in a presentable form. Thank you again
Fuzzy

CB,
Thank you for all the work and different ideas. I have been working on the "Lansky" idea today and it seems to be a good fit for me. Thank you.
I have some time over the next few days so will get out to my shop and put it to a test.
Regards
Fuzzy

Thank you all, for the ideas and direction. I am going to try and build a jig with the ability to pivot, etc. will post what I come up with, well if I am successful
Regards
Fuzzy

Hi all,
I am a new owner of a T-8. I am a fan of Ulu blades for some of my cutting chores.
My question is: is there a fixture or holder to hold or modify to hold an Ulu blade? I realize I can free hand the blade but would like to be more controlled as it is M-2 steel and can take a while to get the edge I desire. Thank you in advance for any ideas or direction
Thank you
Fuzzy