News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - madeiranlotuseater

#1
Rick,

Many thanks for your information.  I left my Karl Holtey plane irons in store for two years and the A2 suffered very badly.  So much so that I decided to order two new blades for my 98s. What an expensive mistake.  Fortunately the planes are made in stainless steel.
#2
Hi there,

I'm new to this community.

My plane irons and chisels are all A2 steel.  The plane irons some 4.5mm thick.  Obviously repairing nicks in these blades means that a lot of metal needs to be removed.  I've tried the Blackstone but, whilst a fine stone, takes forever to grind away A2.

My question is, will the new Diamond Stones from tormec be up to the job? Never cheap in the first place.  More expensive still when I bought a Blackstone wheel. These diamond ones??????