I use 24mm pin Euro inserts on my shaper/spindle moulder and wish to keep them sharp. This is a pricey jig and I'd like to assure it's efficacy before buying. Does it do a respectable job better than hand lapping on a stone? Also I have a 2000 Super Grind and will it work with this machine? I assume i'd need to also purchase the horizontal support base.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com