I found that my wheel was not quite round, so I touched it up with the diamond dresser, and it seems to be a bit better now.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Sharpening Roughing Gouges
May 24, 2006, 04:32:01 PM
I have been singularly unsuccessful in sharpening my roughening gouge.
All I'm trying to do is get the perfect, mirrored, uniform edge that Jeff got when in Atlanta.
How about some tips? ... or a new demo video?
Which jig do you suggest? Which direction? Anything else that might be useful?
All I'm trying to do is get the perfect, mirrored, uniform edge that Jeff got when in Atlanta.
How about some tips? ... or a new demo video?
Which jig do you suggest? Which direction? Anything else that might be useful?
Pages1