It's a square 2000, and it's almost new. I wouldn't trust straightening it since it is severlt bent, but if changing the shaft and housing for a t7 goes around the 270ish I'll have an almost new tormek I think is a fair deal. I refuse to put aside a good machine.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Housing change
March 26, 2018, 09:49:15 PM
Thanks a lot Ken, I will contact Tormek support, I was willing that maybe someone else have had a similar experience.
Best
Best
#3
General Tormek Questions / Housing change
March 26, 2018, 02:32:13 PM
Hi, I'm new to the forum. I bought a very nice slightly used square 2000 Tormek but the shipping managed to drop it hard and now the housing and the main shaft are completely bent. Do the parts of the 2000 will fit a t7 housing?
Best
Best
Pages1