News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - osterdahl

Pages1
#1
Knife Sharpening / Re: Grinding question
August 23, 2018, 08:21:10 PM
I can´t say "perfectly round", if I should look in a microscope maybe it would look terrible...  :)
But to me it was ok. And my daughter said it was SHARP!  8)

#2
Knife Sharpening / Re: Grinding question
August 23, 2018, 04:34:11 PM
Hello again.
A good nights sleep and some trying solved the problem!
A weird angle for the jig provided enough space for me to be able to go straight on the first bit of the blade. Then I combined lifting an pivoting on the radius. Worked real well!
#3
Knife Sharpening / Re: Grinding question
August 23, 2018, 10:39:26 AM
Thank You Rich for pointing me to Your site! Bookmarked!
#4
Knife Sharpening / Re: Grinding question
August 23, 2018, 08:09:02 AM
"SVD-110"
#5
Knife Sharpening / Re: Grinding question
August 23, 2018, 08:08:17 AM
Thank You for the answer!
I did not think of the SVS-110...
But, I have sharpened a pizza slicer with that!
I will test this.
#6
Knife Sharpening / Grinding question
August 22, 2018, 09:54:50 PM
Hello.

I am looking for a tip which technique I should use when grinding this knife?
I have tried to attach the jig in different angels in relation to the edge.
I have also tried to lift, pivot and a combination of both techniques. Nothing works...
The edge-angel gets too steep towards the tip.
Hope You understand despite my english...

I have also contacted Tormek support, but is awaiting their answer.

//Leif


Pages1