Hi, new member and new to using the Tormek.
I have not tried it yet but see that the scissor sharpening jig is not really allowing me to get the proper angle on my wife's really small scissors that she uses to cut thread while crocheting. The scissors are so small that there is not enough blade protruding from the jig to allow for the 20 degrees or so that it has on it (they are cheapies and the original grind is horrible!)
Any solutions to this? I was thinking perhaps grabbing onto the handle instead of the actual blade, as shown in the videos but thought to ask here of there any of you have a better solution to this.
Thanks!
I have not tried it yet but see that the scissor sharpening jig is not really allowing me to get the proper angle on my wife's really small scissors that she uses to cut thread while crocheting. The scissors are so small that there is not enough blade protruding from the jig to allow for the 20 degrees or so that it has on it (they are cheapies and the original grind is horrible!)
Any solutions to this? I was thinking perhaps grabbing onto the handle instead of the actual blade, as shown in the videos but thought to ask here of there any of you have a better solution to this.
Thanks!