I can't be the first person to notice this. If I use the Tormek TT-50 Truing Tool it does a very nice job. But when I spin the machine around and install the Tormek DBS-22 Drill Bit Sharpening Attachment the slide does not run parallel to the stone. The solution of course is to install a diamond dresser in place of a drill bit. The first one I tried was a diamond burr with a radius end which worked pretty well. But Busy Bee Tools has what they call a 'Diamond Dresser With Handle' Part # D3744 which might work even better. Note Tormek: Maybe this is something you should look into. Steve.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com