I recently ordered a MSK-250 for my older Tormek 2000 (2006 vintage) unit. The replacement shaft is about 1 inch shorter in length than my original shaft. When the leather drive wheel is secured to the new shaft there aren't any threads exposed when the SG-250 stone is attached to the other end. I wonder if I got a MSK-200 shaft by mistake. I've attached a picture to show the differences. I purchased this via Amazon 2 months ago and due to work issues I was unable to attempt installation until this last weekend. If the part was just put in the wrong box I would like to exchange it for the correct part.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com