News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - gijssom

#1
Hello everybody,

I'm having difficulty truing the SG-250 stone of my T8.

What I am observing is that there is a lot of resonance/vibration when truing the first (about half) part of the stone (from outside to inside).
The result is a wrinkled pattern on the first (outer) half of the stone, the second half has a smooth finish.
I'm lowering the TT-50 no more than one mark or digit and I'm completing the process in no less than 90 seconds.

What am I doing wrong?

I have attached a picture to illustrate what is happening.

Kind regards,

Gijs