Thank you for all the responses I've received.
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Tormek Questions / Re: Water trough knob
November 14, 2017, 02:22:02 PM
My water trough knob just sprung off my T-8. The machine was running unattended whilst the stone was absorbing water.
The washer and spring were flung across the room.
This fault is a little surprising and may hint at a design or build issue as I don't push the machine hard at all and have only used it a few times to date.
Any links to repair text/videos would be greatly appreciated.
ta
The washer and spring were flung across the room.
This fault is a little surprising and may hint at a design or build issue as I don't push the machine hard at all and have only used it a few times to date.
Any links to repair text/videos would be greatly appreciated.
ta
Pages1