Advanced Machinery site says they will ship in November
- Welcome to Tormek Community Forum.
News:
Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
Knife Sharpening / Re: Possible small production run of Adjustable Offset SVM-45
September 01, 2019, 07:02:02 AM
Second that. I'm very interested.
#3
Knife Sharpening / Re: Struggling to get the burr
August 26, 2019, 04:31:36 AM
I think if you read Wootz' book all your questions will be answered.
Pages1