News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - jmartin80

Pages1
#1
General Tormek Questions / Re: supergrind 2000 issues
May 07, 2017, 04:06:12 AM
Hello,
I just bought a  Supergrind 2000 on eBay. The universal support is not threaded, but I want to cut threads in it so I can use a micro adjust nut. Does anyone know what thread size I should use?
Thank you,
Jon
Pages1