News:

Welcome to the Tormek Community. If you previously registered for the discussion board but had not made any posts, your membership may have been purged. Secure your membership in this community by joining in the conversations.
www.tormek.com

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Mickey

Pages1
#1
Planer Blade Sharpening / Planer blade minimum width
July 30, 2018, 03:36:14 PM
The SVH-320 planer blade attachment instructions state the minimum blade width is 13mm or a hair over 1/2 inch. Is there any workaround for that to accommodate a 7/16ths inch wide blade, or is the 1/2 inch minimum a hard stop to keep the lower edge of the grinding jig support slightly off the wheel?

Thank you.

Mickey
Pages1